![]() ![]() The best way to check the calibration is to open the driver menu on PC to check if the right gears are engaged. Move the shifter into sixth gear position and press "Start Button"ġ3.1 Move the shifter into seventh gear position and press "Start Button"ġ3.2 If your Shifter does not have a 7th gear keep the shifter in 6th position and press "Start Button"ĭisplay will turn off again -> Calibration done! Move the shifter into fith gear position and press "Start Button"ġ2. Move the shifter into fourth gear position and press "Start Button"ġ1. ![]() Move the shifter into third gear position and press "Start Button"ġ0. Move the shifter into second gear position and press "Start Button"ĩ. Move the shifter into first gear position and press "Start Button"Ĩ. Move the shifter into reverse gear position (push stick to the very left position and up) and press "Start Button"ħ. Move the shifter into neutral position and press "Start Button"Ħ. Press "Tuning Button" + "Start Button" simulanously (the position of these buttons may vary depending on the CSW rim you are using!)ĥ. Wait until auto-calibration and boot sequence are finishedĤ. Connect the H-gated shifter to "shifter port 1" of your wheelģ. ![]() Please do it again after the wheel is updated/flashed.ġ. The calibration has to be done only once and will be saved in the firmware but it will be deleted after a firmware update. Before first use the H-gated shifter must be calibrated to work properly. ![]()
0 Comments
Leave a Reply. |